With HOBBYWING’ s Program Card, you can easily set the programmable value of Electronic Speed Controller (ESC) for brushless motor. Now you can just forget the complicated and boring programming method with the throttle stick on your transmitter.
HOBBYWINGTM Program Card has a friendly user interface and is easy to use. It is as small as a business card, so you can put it in your pocket when you are on field.
1. SPECIFICATION:
1.1. Size: 92mm*52mm*6.3mm (length*width*height)
1.2. Weight: 26g(With a extension cable for connecting Program Card to ESC)
2. USER MANUAL:
2.1. FRONT PANEL:
2.1.1. Use “up/down
2.1.2. Brake: When “Brake ” is ON, the motor will stop quickly after the throttle stick is moved to bottom;
2.1.3. Low Voltage Protection Mode (Cutoff Type)：When “Soft-Cut” is selected,
the ESC will reduce the output power gradually; When “Cut-Off” is selected,
the ESC will immediately cut off the output power to motor.
2.1.4. Low Voltage Protection Threshold (Cutoff Voltage)：
l For Li-xx battery (Li-ion or Li-poly)，number of battery cells are judged automatically，Low / Medium / High cutoff voltage of each cell are: 2.6V/2.85V/3.1V.
For example: 3 Cells Li-Poly, when “Medium” cutoff voltage is set,
the cutoff voltage is: 2.85*3=8.55V
l For Ni-xx battery (NiCad or NiMH), Low / Medium / High cutoff voltages
are 0%/45%/60% of the startup voltage. For example: when a 10 cells NiMH
battery pack is used, its fully charged voltage is 1.44*10=14.4V, when medium
cutoff voltage is set, the cutoff voltage is : 14.4*45%=6.5V
2.1.5. Music: 4 LEDs has 16 possible states, representing 16 rhythms.
(For ESC supports above 6S Lipo, these 4 LEDs are used to indicate the
cells number of your Lipo battery pack)
2.2. CONNETING PROCESS:
2.2.1. Disconnect the power pack from ESC;
2.2.2. Disconnect the BEC cable from receiver, then connect it to program card;
2.2.3. Connect the power pack to ESC;
2.2.4. The LEDs on program card will light, shows the current
programmable value of the ESC;
Remark: THE SEQUENCE OF STEP 2.2.2 AND STEP 2.2.3 IS IMPORTANT!
Please connect the BEC cable to program card firstly, and then
connect the power pack to ESC. Otherwise, the program card cannot work properly.
| 
